DLP 3D Printer Exposure Times on DruckWege Resins

DLP 3D Printer Exposure Times on DruckWege Resins

DruckWege Resins on DLP 3D Printers

1 AUG 2018 – This blogpost gives some summarized results on the settings for DruckWege Resins on DLP 3D Printer devices. We will update the table gradually and update through new posts on DLP 3D printer exposure times for our resins, also on new releases and versions. Once gathered on all resin types for DruckWege materials, we will issue a material guide this year enabling all material info at a glance.

DLP UV 3D Printer Resin Settings

DLP 3D printers vary (as an open system) throughout various technologies (light source-dependent) and range from the applied DLP beamer type to the irradiation direction (bottom-up or top-bottom). We figured the following resin settings to be adjusted in an according slicer software, which can be adapted to DruckWege resins at the following parameters, whereas the table is for Baselayer (seconds) / Regular Layer (seconds) / Layer height (millimeters), used at 8 baselayers in general – we used a DLP light source at the following spectrum and an illumination distance of 20 cm:

Type D Blue Standard 8s/3s/0.1mm
Type D Grey Standard 10s/5s/0.1mm
Type D Orange Standard 10s/5s/0.1mm
Type D Pigment-free/Clear Standard 10s/3s/0.1mm
Type D Black Standard 10s/4s/0.1mm
Type D Green Standard 8s/3s/0.1mm
Type D Red Standard 8s/3s/0.1mm
Type D White Standard 15s/7s/0.1mm
Type D Pro Black 15s/4s/0.1mm
Type D Pro Flex Clear 15s/3,5s/0.1mm
Type D Dental Standard 20s/7s/0.1mm

DruckWege Resins